|Software||Cisco Unified Wireless Network Software Release with AireOS wireless controllers:|
8.1 MR1 or later for the Cisco Aironet 1850 Series Access Points
|Deployment modes||Centralized local, Standalone, Sniffer, Cisco FlexConnect, Monitor, OfficeExtend, Mesh|
|Supported wireless LAN controllers||Cisco 2500 Series Wireless Controllers, Cisco Wireless Controller Module for ISR G2, Cisco Wireless Services Module 2 (WiSM2) for Catalyst 6500 Series Switches, Cisco 5500 Series Wireless Controllers, Cisco Flex 7500 Series Wireless Controllers, Cisco 8500 Series Wireless Controllers, Cisco 5760 Series Wireless Controllers, Cisco Catalyst 3650/3850 Series switch with integrated controllerCisco Mobility Express|
|802.11n version 2.0 (and related) capabilities||4×4 MIMO with four spatial streamsMaximal ratio combining (MRC)20- and 40-MHz channels PHY data rates up to 600 Mbps (40 MHz with 5 GHz)Packet aggregation: A-MPDU (Tx/Rx), A-MSDU (Tx/Rx)802.11 dynamic frequency selection (DFS)Cyclic shift diversity (CSD) support|
|802.11ac Wave 1 and 2 capabilities||4×4 MIMO with four spatial streams, single-user MIMO4x4 MIMO with three spatial streams, multiuser MIMOMRC802.11ac beamforming (transmit beamforming)20-, 40-, and 80-MHz channels PHY data rates up to 1.7 Gbps (80 MHz in 5 GHz)Packet aggregation: A-MPDU (Tx/Rx), A-MSDU (Tx/Rx)802.11 DFSCSD support rogue device detection|
|Integrated antenna||2.4 GHz, gain 3 dBi, internal omni, horizontal beamwidth 360 5 GHz, gain 5 dBi, internal omni, horizontal beamwidth 360Â |
|External antenna (sold separately)||Certified for use with antenna gains up to 6 dBi (2.4 GHz and 5 GHz)Cisco offers the industry’s broadest selection of antennas, delivering optimal coverage for a variety of deployment scenarios|
|Interfaces||1 x 10/100/1000BASE-T autosensing (RJ-45), Power over Ethernet (PoE)1 x 10/100/1000BASE-T autosensing (RJ-45), AUX (used for Link Aggregation)Management console port (RJ-45)USB 2.0 (enabled via future software)|
|Indicators||Status LED indicates boot loader status, association status, operating status, boot loader warnings, boot loader errors|
(W x L x H)
|Access point (without mounting bracket): 8.3 x 8.3 x 2 in. (210.8 x 210.8 x 50.8 mm)|
|Weight||3.12 lb (1.41 kg)|
|Environmental||Cisco Aironet 1850e|
Nonoperating (storage) temperature: -22Â to 158 F (-30Â to 70 C)Nonoperating (storage) altitude test: 25 C, 15,000 ft.Operating temperature: -4Â to 122 F (-20Â to 50 C)Operating humidity: 10% to 90% (noncondensing)Operating altitude test: 40 C, 9843 ft.
|System memory||1 GB DRAM256 MB flash|
|Input power requirements||AP1850: 44 to 57 VDC power supply and power injector: 100 to 240 VAC; 50 to 60 Hz|
Note: When deployed using a Power over Ethernet (PoE) specification, the power drawn from the power sourcing equipment will be higher by some amount, depending on the length of the interconnecting cable.
|Powering options||802.3atEnhanced PoECisco power injector, AIR-PWRINJ4=Cisco local power supply, AIR-PWR-C=Cisco power injector, AIR-PWRINJ5= (Note: this injector supports 802.3af only)802.3af|
Note: If 802.3af PoE is the source of power, (1) the 1852e 2.4-GHz radio will shift to 2×3 from 3×4, (2) The USB port and AUX Ethernet port are disabled on both the 1852i and 1852e.